Read the system manual" S Programmable Controller" Prior to installation, connecting up and commissioning, read the relevant sections in the system manual" S Programmable Controller"refer to the documentation in the Appendix. Choose the location where you would like to install the DA Server and then click the Next button and then Next at the following screen to proceed.
The default location for a 64 bit Operating System will be the location in the screenshot below: Click the Finish button to complete the installation of The single parts of the remote TSAPs in DASSIDirect are called Remote Rack No, Remote Slot No and Connection Resource. This naming convention was meant for S7300 and S7400 PLC's. This naming convention was meant for S7300 and S7400 PLC's. S Programmable controller System Manual (pdf 864p) This Tech Note provides the Wonderware DASSiDirect information needed to get consistent data access from the S7 1200 and 1500 PLC with those new features.
SITUATION Since the security protection feature was added in the PLC side, the steps in this document need only to be implemented in the within the PLC. 9 SIDirect DAServer Users Guide Chapter 1 Introduction This section is an overview of the Wonderware SIDirect DAServer (Data Access Server), including the I'm not aware wheather Wonderware Intouch through DASSIDIRECT has a suitable driver for S.
You have check the issue only from the S driver Wonderware side. Yes this is true, there is no" official" drivers for the S with Intouch but the driver for the S works fine.
Hi all, I have been using an S along with the Wonderware DASSIDirect server to communicate with Wonderware Intouch. Everything is working smoothly, however if I try and access a memory bit in the DASSIDirect server it does not pick it up what so ever. Apr 07, 2009 Under the local node the DAServer name is (Figure 1 below). Figure 1: DASSIDirect DAServer in the SMC Startup Type from Disable to Manual. Configuring SIDirect DAServer to Communicate with How to use DASSIDirect DAServer Together with Siem